Drawer Slide Installation Template Compatible with Tandem, Undermount Drawer Slide Mounting Template for Rear Notch & 6mm Drilling, Precision Jig for Cabinet Drawer Hardware Installation(2pcs)

Compatible with TANDEM drawer slide installation template — this 3D-printed jig combines a 6mm drill depth stop, a center notch guide, and left/right positioning holes into one tool. It indexes off the drawer side and back panel top, fitting 1/2“, 5/8”, and 12mm thick boards (up to 3/4“). With a trim router and flush trim bit, each drawer takes under one minute — no measuring or marking needed. The jig alone is included; a 6mm drill bit, stop collar, router, and bearing-guided bit are required separately. Always secure the jig and drawer before routing.

• 3D-printed jig compatible with TANDEM slides. Cuts rear notch and drills 6mm holes
• Top depth guide sets consistent 6mm drill depth. Prevents blow-through.Use on left side with L hole, right side with R hole. Repeat on both sides
• Center cutout guides a router or chisel for the rear notch
• Bottom L/R holes position 6mm screws. Fits 1/2" to 3/4" thick boards
• Important Note: This is a third-party replacement part, Brand names are used only to indicate compatible with TANDEM. This product is not affiliated with or endorsed by any brand owner